Tired Shower Grout Refresh

Keeping the tile and grout in shower cubicles clean is often a headache for homeowners and this cubicle at a house in Edinburgh was certainly no different. You can see from the photograph below that although the glazed ceramic tiles were in good condition they were being made to look grubby by the stained condition of the adjacent grout and there were also signs of mould build-up. If you catch this early you can overcome the problem spraying on a product called Tile Doctor Mould-Away however in this case a full refresh was required.

Shower Renovation Before Cleaning

Cleaning Ceramic Tile and Grout

We started by spraying the tile and grout down with Tile Doctor which is a strong alkaline cleaner Pro-Clean, spraying it on mixes it with helping it to stick to Vertical surfaces where it can get to work on the dirt. We left it to dwell for ten minutes before scrubbing it in by hand using a stiff grout brush; this process certainly improved the grout but unfortunately it had become too badly stained to be satisfactory so it was agreed with the owner that we would recolour the grout using a white grout colourant.

Recolouring Grout

The grout colourant comes in a tube and is very straightforward to apply although I must admit the work is quite tedious. Two coats of white colourant were required to get the uniform appearance needed and I think you will agree the effect is quite transforming. The other advantage of these particular colourant products is that they are epoxy based and form a barrier of the grout preventing future staining and making it very easy to clean going forward.

Shower Renovation After Cleaning

The last step was to carefully remove the existing silicon strip along the base of the cubicle with a sharp nice and replace with new. The final result was a shower cubicle that looked recently installed.
 
 
Source: Tile, Stone and Grout Cleaning and Sealing in Edinburgh

Using Tile Doctor Mould Away

This shower cubicle was installed in the main bathroom of a house in Bishopton where the grout had become quite grubby and the Ceramic tiles were looking quite dull. The owner was thinking about re-tiling the bathroom and thought they would give us a call first to see if we could refresh the look without the expense.

Gruby Ceramic Tiled Shower in Bishopton Before Gruby Ceramic Tiled Shower in Bishopton Before

Cleaning Ceramic Tile and Grout

We started by spraying the tiles with Tile Doctor Oxy-Pro which is a strong high-alkaline cleaner especially formulated and packaged for cleaning showers. The spray delivery is important as mixing the cleaning product with air makes it lighter and helps it cling to the tile and grout. The Oxy-Pro was left to soak into the tiles for around 15 minutes before being scrubbed into the tile and grout using a stiff grout brush. This action cleaned up the grout and tile nicely removing stains from shampoos and soaps etc.

Removing Mould from Grout

The grout was looking much improved but there was however some evidence of mould remaining which needed dealing with. To tackle this we used Tile Doctor Mould Away which is designed to remove mould off Silicone and Grout. It’s very easy to use, you simply spray the Silicone or Grout to be treated with Mould Away then leave to soak in for five minutes and then scrub with a brush and rinse with water repeating the process until the mould has disappeared.

Gruby Ceramic Tiled Shower in Bishopton After Gruby Ceramic Tiled Shower in Bishopton After

It took a fair amount of manual effort but the results were well worth it as you can see.
 
 
Source: Expert Ceramic Tile Maintenance advice